Microtest TSB-67 - 568A Annex E Manuel D’Utilisation

To display the 

screen, press the 

 key, then 

, then highlight the Autotest to edit, then press 

 then select Limits. This screen

lets you specify the PASS/FAIL limits used in tests.
Press the

 Ñ 

or

 Ò 

arrow key to highlight the test for which you want to edit the limits.

Press

 to display the limits screen for the highlighted test. Or, press the number on the

keypad that corresponds to the test for which you want to change the limits.
After editing the selected limits, press 

 to save these changes and to return to the

 screen.

If you have created a new Autotest by editing the Autotest name or by editing a factory-
programmed Autotest, and if you want the new test to be the default Autotest, press 

until you return to the 

 screen, then press 

Note: See the individual test sections for information on customizing specific test limits.

To display the 

 screen, press the 

 key. This screen is displayed while

Autotest is running. The Autotest name is displayed at the top of the screen and the cable type is
shown in the top center of the screen. Each pair being tested is displayed in the lower left corner of
the screen. The name of each test being run is displayed in the lower right corner of the screen. A
status bar at the bottom of the screen indicates the progress of the Autotest.

Press the 

 key at any time to cancel the Autotest.

Note: The Injector must be attached to the far end of the cable during Autotest. If it is not, the
Scanner screen will display the following:
Searching for Injector . . . (Injector Not Found)

To display the 

screen, press the 

 key, or press 

 key and select 

. This screen is displayed when Autotest completes or when

saved Autotest results are selected for viewing.

The Autotest name is at the top right of the display and the PASS/FAIL indicator is in the center.
The number of failed tests, if any, is displayed next to the PASS/FAIL indicator. An Autotest will
PASS if all the selected tests meet the specified criteria. An Autotest will FAIL if one or more
selected tests fail. When the Margin Display is set to 

an Autotest will

marginally PASS (*PASS) if one or more NEXT, Attenuation or Length measurements marginally
passes. A marginal PASS is defined as a PASS result that is closer to the PASS/FAIL threshold than
the accuracy of the Scanner.

Press 

 to display Autotest results, then use the 

Ñ 

or 

Ò 

arrow keys to scroll through

the tests. The tests you view depend on the tests you have selected to run in 

.

See Selecting Tests to Run During Autotest for more information.

Press 

 to save test results and exit. See Saving Autotest Results for more information.

Note: The 

 key is unavailable when viewing the 

 screen via the

 feature.