Manualsbrain.com
  1. Manuels
  2. Marques
  3. Marantz
  4. Av Sound Receiver NR1501
  5. Manuel D’Utilisation

Marantz Av Sound Receiver NR1501 Manuel D’Utilisation

Télécharger
Page de 50
NAMES AND 
FUNCTIONS
12
BASIC 
CONNECTIONS
BASIC 
OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
BASIC 
CONNECTIONS
BASIC 
OPERA
TION
ENGLISH
BASIC CONNECTIONS
CONNECTING THE ANTENNAS
CONNECTING THE SUPPLIED ANTENNAS 
The supplied antennas are for indoor use only.
GND
GND
AM
AM
ASSEMBLING THE AM LOOP ANTENNA
Insertting the tabs into the base as shown.
CONNECTING THE AM ANTENNA CABLE
Press and hold 
Insert wire 
Release
White
Black
Notes
•  During use, extend the FM antenna and move it in various directions until the clearest sound is received.
  Fix it with push pins or similar implements in that cause the least amount of distortion.
•  Set in the direction and position it to where you receive the clearest sound. Put it as far away as possible from 
the unit, televisions,speaker cables and power cable.
 CONNECTING AN OUTDOOR ANTENNAS  
If you experience poor reception quality, an outdoor antenna may improve the quality.
Keep the antenna from noise sources (neon signes, busy roads, power lines, transformers, etc)
FM
FM
(
(75
75
Ω
Ω))
GND
GND
AM
AM
FM External 
Antenna
AM Loop Antenna
Black
White
Ground
AM External 
Antenna
16 to 32ft (5 to 10m)
Vinyl-coated wire
Notes
•  Do not remove the AM loop antenna.
•  Do not connect the supplied FM antenna.
•  The GND terminal on this unit does not function as a safety ground.
CONNECTING OF AC POWER CABLE
 
1.
  Plug the supplied AC power cable to the 
AC IN socket on the rear panel of the main 
unit.
AC IN
 
2.
  Plug the power cable into an AC outlet.
AMP OPERATION
TURNING ON THE UNIT
 
1.
  Connect the AC power cable to the wall 
outlet.
 
2.
  Turn the power on to other units connected 
to this unit.
 
3.
 Press 
the 
POWER ON/STANDBY button of 
this unit. Every time the button is pressed, 
the power to this unit toggles between on 
and standby.
 
  To activate power using the remote 
controller, press the AMP button, followed 
by the ON button and SOURCE ON/OFF 
button of the remote controller.
BASIC OPERATION