Marantz Av Sound Receiver NR1501 Manuel D’Utilisation

ENGLISH

No image on the 
monitor TV.

•  The monitor TV connection, 

input switching, etc., are not set 
up correctly.

•  The unit has an HDMI 

connection to the source 
component, but no HDMI 
connection to the monitor TV. 

•  See the monitor TV's instruction 

manual. 

•  Make an HDMI connection to 

the monitor TV. 

11

The audio or 
the image does 
not match the 
selected source. 

The input cables are not correctly 
connected. 

Connect the cables properly, 
referring to the connection 
diagram.

9, 10, 11

Cannot record to a 
VCR, etc. 

•  The video recording component 

jack does not match the source 
component jack. 

•  A copy-protected signal is being 

received. 

•  Make sure the recording 

component jack matches the 
source component jack. (Video 
input)

•  Video signals that include copy-

protected signals cannot be 
recorded.

10

The converted 
video signals are 
disturbed.

When special playback is 
performed by the video deck, the 
conversion may not be carried out 
normally, causing the video signals 
to be disturbed and preventing the 
images from being shown.

Connect a monitor TV using the 
same format (video or component) 
as the source component.

10

There is no picture 
with the HDMI 
connection.

The HDMI cable is improperly 
connected.

Check the HDMI cable connection. 

11

The unit is connected with a non-
spec HDMI cable. 

Use of a cable no longer than 5 
meters is recommended to ensure 
stable operation, prevent picture 
degradation, etc. 

11

The connection between 
components over an HDMI 
connection has not been 
authenticated. 

Turn the power on again to all 
the components on the HDMI 
connection.

−

The HDMI settings are incorrect.

Make sure the unit’s HDMI 
settings are correct. 

−

Set the unit for HDMI input, as 
explained in the instruction manual 
of the video component (TV, 
projector, etc.). 

−

Make settings to enable HDMI 
output, as explained in the 
instruction manual of the source 
device (Blu-ray disc player, Set Top 
Box, etc.). 

19

Match the resolution for both 
components, as explained 
in the instruction manual of 
the component on the HDMI 
connection. 

−

The unit is connected to the video 
component (TV, projector, etc.) by 
DVI connector.

Connect an HDCP-compatible 
video component.

−

The power to the unit is turned off. 
(HDMI connections are not enabled 
when the unit is in STANDBY mode.)

Turn on the main power to the unit.

12

It takes time for 
the image to be 
displayed over an 
HDMI connection.

The connection is being 
authenticated between components 
on the HDMI connection.

Some HDMI components require 
time for authentication. There is 
nothing wrong with the unit.

−

There is no audio 
playback over an 
HDMI connection.

The HDMI settings are incorrect.

Make settings to enable HDMI audio 
output, as explained in the instruction 
manual of the source device (Blu-ray 
disc player, Set Top Box, etc.).

19

Set so that the HDMI audio output 
setting matches the signals 
supported by the unit, as explained 
in the instruction manual of the 
source device (Blu-ray disc player, 
Set Top Box, etc.).

−

ON has been set for HDMI AUDIO 
OUT on the SYSTEM SETUP menu.

No sound is heard from the unit 
when ON is set for HDMI AUDIO 
OUT. Select OFF as this menu 
item's setting.

19