Lucent Technologies Window SLV 9124 Manuel D’Utilisation

Troubleshooting

9124-A2-LB20-00

March 2000

An IP Ping test can be run to test connectivity between the FrameSaver unit and
any FrameSaver unit, router, or NMS to which it has a route.

Times when you might want to run an IP Ping test are:

H

To test connectivity between the FrameSaver unit and any FrameSaver unit
in the network to verify that the path is operational. Select Procedure 1 to
Ping any far-end FrameSaver unit.

H

To verify the entire path between a newly installed remote site FrameSaver
unit and the central site NMS. During a remote site installation, an IP Ping
test is typically run from the remote site to Ping the NMS at the central site.
The remote FrameSaver unit must have SNMP trap managers configured,
and one of those trap managers must be the central site NMS. Select

"

To Ping any far-end FrameSaver unit:

1. Select the IP Ping test.

→

→

2. Enter the IP Address of the device the Ping is being sent to, then select Start.

If the FrameSaver unit has just initialized, or the far-end unit has just
initialized, it may take about a minute for the units to learn the routes via
the proprietary RIP.

3. Verify the results of the IP Ping test.

— While the test is running, 

  is displayed in the Status

field.

— When the test is finished, 

 should appear

as the Status (nn being the amount of time the test took in milliseconds).

If any other message is displayed, additional testing will be required.