Logitech 700e Fascicule

Certain uses of security camera 
products and audio devices, such as 
employee monitoring, surreptitious 
viewing and recording of images and/or 
audio, or the use, publication or 
distribution of image and/or audio 
recordings, are prohibited or restricted 
by country, state and local laws. 
Be sure to comply with the laws in your 
country, state, and locality when using 
Logitech Alert products and services.

1) Be sure that Logitech Alert Commander sotware is running on the PC 

before beginning installation of camera.

• Shortly after connecting, your camera will appear in Alert Commander software. You can now move the camera to its desired location.

1 Logitech Outdoor Camera
2 Camera power supply
3 Power supply cable (yellow tips)

4 Mounting accessories
5 microSD™ card adapter
6 System Requirements Guide

Getting started with
Logitech

®

 

Alert

™

 700e 

Add-On Camera 

!

!

When prompted to connect your camera:  

1) Unscrew the hatch from the back of the camera and lift. 
1a) Plug the yellow cable connector into the port.  
1b) Screw the hatch firmly in place.

2) Unscrew the hatch from the power supply. 
2a) Plug the yellow cable into the power supply port.  
2b) Screw the hatch firmly in place. 
2c) Mount the power supply unit to the wall. 
2d) Plug the power connector into the plug slider and plug the power supply into an 
outlet.  

The wall mount allows you to easily fasten your camera to a wall, post, 
overhang, or other surface.  
1) Start by pre-drilling holes into the base surface and then fastening the 
mouting base with the included screws.

  

2) Assemble the mounting arm and attach it to the base. 
3) Attach the camera to the mounting arm.
 

!

RECOMMENDATION: 
Mount the Outdoor Camera under an eave or 
other overhang so that it is not exposed to direct 
sunlight.

The power supply unit is weatherproof and can be installed outdoors. Use these tips to 
ensure reliable power supply usage. Make sure the outdoor outlet is weatherproof. Do 
NOT place on the ground.

1) Do NOT plug the power supply into a surge protector or power strip as they 
interfere with the cameras. Surge protectors are built-in to the power supply and 
protect the cameras.

2) Do NOT plug the power supply into the wall so that it lays horizontally or flat.  

3) Do NOT mount the power supply upside down. Keep the cable connector port on 
the bottom. 

4) Avoid direct sunlight.

!

CAUTION: If left in sunlight, surface may be hot to the touch.

Quick-start 

guide

 

™ 

700e/750e

System Requirements 

& Support Guide