Little Wonder HPV 5611 Manuel D’Utilisation

1.  Attach the collector assembly to the base unit:

 

•  Bolt the collector assembly to the frame with 

4 sets of bolts, washer, and nuts

 

•  Slide the rectangular end of the collector 

over the housing and mount the flange with 2 
sets of washers and nuts

2.  Attach the throttle control cable to the handle 

on the collector assembly:

 

•  Bolt throttle control lever to handle with 

washer and nut 

 

•  Secure throttle cable to handle with cable 

ties in 2 places

3.  Install the band clamp into the debris bag (wear 

gloves when handling band clamp):

 

•  Slide the bracket end of the band clamp 

through the left side opening of the sleeve on 
the debris bag until it emerges from the right 
side

 

•  Feed the tail end of the band (on the clasp 

side) behind the bracket in the sleeve

 

•  Pinch the wire form on the clasp together and 

connect it through 2 holes in the adjustment 
bracket such that it will close tightly over the 
collector

4.  Connect the debris bag by placing it over the 

bottom lip of the collector and closing the clasp 
to secure the bag.  Adjust the clasp wire form to 
the appropriate hole position on the bracket to 

insure a tight fit. If the bag will not fit tight within 
the range of the 3 adjustment holes, insert the 
bag seal strap:

 

•  Unhook the wire form from the bracket 

 

•  Pull the tail end of the band back out from 

behind the bracket

 

•  Feed one end of the seal strap behind the 

metal band and through the channel to the 
other side

 

•  Tuck the other end of the seal strap behind 

the bracket (overlapping the lead end of the 
seal strap)

 

•  Feed the tail end of the band clamp behind 

the bracket (overlap the seal strap)

 

•  Connect the wire form to the appropriate 

holes in the bracket and secure the debris 
bag to the collector

5.  Attach nozzle assembly to base unit:

 

•  Attach one end of the hose to the nozzle 

assembly with the bridge clamp Assembly

 

•  Slide the other end of the hose over the 

edge of the inlet on the front plate

 

•  Hook one side of the nozzle bracket over 

the front axle

 

•  Bend the other end of the nozzle bracket 

inward to hook it over the axle and engage 
the pins on the wheel bracket with the slots 
on the nozzle bracket

 

•  Secure the hose to front plate inlet with the 

 

•  Attach the nozzle cable end fitting through 

the hole in the nozzle bracket

6.  To remove nozzle assembly (for purposes of 

storage, or clearing blockages):

 

•  Turn engine off and disconnect spark plug

 

•  Loosen hose clamp on the front plate with 

flathead screwdriver or 5/16 wrench

 

•  Slide hose off of front plate inlet

 

•  Bend one side of nozzle bracket inward and 

twist the assembly to remove the hook from 
the axle 

 

•  Twist back and lift to remove the other side of 

nozzle bracket from the axle