Leica TPS - System 1000 1000Z01 Manuel D’Utilisation
© Leica
TPS-System 1000 Programs-2.3.1en
135
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
Calculate Mode
• Calculate Horizontal and Vertical Sets
The display-format is the same for horizontal and
vertical directions. The data displayed, refer to the
selected calculation.
Standard deviations of a single direction in both faces
(mR) and the standard deviation for an averaged
direction from all sets (mM) are calculated.
vertical directions. The data displayed, refer to the
selected calculation.
Standard deviations of a single direction in both faces
(mR) and the standard deviation for an averaged
direction from all sets (mM) are calculated.
Computations of standard deviations require, that all
targets and sets are observed in two faces. Exceptions
may exist, in which case the standard deviation should
be seen as an approximation to be used as a field
control. The correct standard deviations a posteriori can
be calculated using the recorded data and a suitable
computation method.
targets and sets are observed in two faces. Exceptions
may exist, in which case the standard deviation should
be seen as an approximation to be used as a field
control. The correct standard deviations a posteriori can
be calculated using the recorded data and a suitable
computation method.
F1
F2
F3
F4
F5
F6
HELP
SETS\ HZ SET RESULTS
14:03
MC
Pts. Active :
4
Set Active
:
2
mR
:
0°00'24"
mM
:
0°00'17"
STORE
MORE
Pts. Active
: Number of observed points used in the
calculation.
Sets Active
: Number of observed sets used in the
calculation.
mR
: Standard deviation of one observed
horizontal or vertical direction.
mM
: Standard deviation of an average
direction from all sets.