Leica TPS - System 1000 1000Z01 Manuel D’Utilisation
© Leica
TPS-System 1000 Programs-2.3.1en
171
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
RO
Road line
Introduction
The manual describes the program "ROAD LINE" for
the Leica TPS 1000 series.
the Leica TPS 1000 series.
PROG_Z26
[km] 0
50
100
150
200
300
centre-line
offset
offset
(+)
centre-line
offset
offset
(-)
points to be
staked
staked
The program is suitable for setting out points which are
determined by chainage and centre-line offset along a
calculated alignment. If V-alignments and cross-
sections are defined for the alignment, the points can be
calculated and set out spatially ("ROAD
STAKEOUT").
Conversely, if a point in the vicinity of the alignment
has been determined by measurement, the chainage and
centre-line offset can be determined ("X-SECTION
CHECK").
This version of "ROAD LINE" is only valid for a GSI
configuration.
determined by chainage and centre-line offset along a
calculated alignment. If V-alignments and cross-
sections are defined for the alignment, the points can be
calculated and set out spatially ("ROAD
STAKEOUT").
Conversely, if a point in the vicinity of the alignment
has been determined by measurement, the chainage and
centre-line offset can be determined ("X-SECTION
CHECK").
This version of "ROAD LINE" is only valid for a GSI
configuration.