Laney Amplification Speaker CX15-A Manuel D’Utilisation

CX12-A

CX15-A

Cxsub-A

Cxsub

Supply Voltage

230V @ 50/60Hz

(factory selected)

or 120V @ 50/60Hz

Power Consumption

330W

600W

Amplifier Power rating rms

165W / 4 ohms

300W / 4 ohms

110W / 8ohms

170W / 8 ohms

Speaker power (r.m.s./Program)

200W/400W

250W/500W

Impedance

Frequency Range

60Hz - 18KHz

50Hz - 18KHz

35Hz - 170Hz

35Hz - 800Hz

Size W*D*H

410*330*620

500*360*700

580 * 505 * 510

Pole stand fitting

35mm diameter

Shipping Weight

24Kg

19.5Kg

34Kg

29Kg

Net weight

20Kg

16Kg

30Kg

25Kg

Line gain (max)

+42dBu

-7dBu to +10dBu

Mic gain (max)

+72dbu

CD gain (max)

+32dBu

Bass ±12dB @ 35Hz

Mid ±10dB @ 2.5KHz

Treble ±10dB @10KHz

Crossover frequency

Switchable Hi Pass

Fixed Lo Pass

-6dB @ 170Hz

12dB octave

Phase switch

yes

extension Loudspeaker socket

yes , for 8 ohm cabinet

link out

Line Out

Yes , full range,0dBu nom.

peak led

Indicates onset of clipping

Cxsub recommended cross over frequency 150Hz - 250Hz

Maximum Pole stand length should be 1 meter otherwise additional support is required

Laney

www.laney.co.uk

Technical Specifications

.General Notes
Amplifier connection. In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off
your sound system.

With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc. BEFORE
turning on your power amplifier. Many products have large transient surges at turn on and off which can cause damage to
your speakers.

By turning on your power amplifier LAST and making sure its level control are set to minimum any transients from other
equipment will not reach your loudspeakers.

Wait until all system parts have stabilised usually a couple of seconds.

Similarly when turning off your system always turn down the level controls on your power amplifier and then turn off its
power before turning off other equipment.

Cables- never use shielded or microphone cable for any speaker connections as this will not be substantial enough to
handle the amplifier load and could cause damage to your complete system.

Rigging or suspended mounting. The rigging or suspended mounting of these speakers can expose members of the
public to serious health risks or even death. Under no circumstances attempt to rig, suspend or otherwise mount
this system unless you are fully qualified and certified to do so by relevant local, state and national
authorities. All relevant safety regulations must be followed. If you are not properly qualified or do not know
of pertinent regulations, consult qualified personnel for advice and assistance.

When mounted on a propriety tripod pole stand ensure the system is fully stable and can not fall over. We do not
recommend poles stands to be used higher than1 metres, without extra support.

Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with
placement and operation to avoid exposure to excessive levels that can cause permanent hearing damage.

Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.