ISonic K8NF4G-SATA2 Manuel D’Utilisation

CAUTION!

For power-saving’s sake, it is strongly recommended to enable AMD’s Cool ‘n’

Quiet

technology under Windows system. See APPENDIX on page 40 to

enable AMD’s Cool ‘n’ Quiet

technology. Since not all K8 754-pin CPU can

support AMD’s Cool ‘n’ Quiet

technology, please check AMD’s website for

details.

This motherboard supports Untied Overclocking Technology. Please read “Un-

tied Overclocking Technology” on page 22 for details.

While CPU overheat is detected, the system will automatically shutdown.

Before you resume the system, please check if the CPU fan on the motherboard

functions properly and unplug the power cord, then plug it back again. To

improve heat dissipation, remember to spray thermal grease between the

CPU and the heatsink when you install the PC system.

For microphone input, this motherboard supports both stereo and mono modes.

For audio output, this motherboard supports 2-channel, 4-channel, 6-channel,

and 8-channel modes. Please check the table on page 10 for proper connection.

Before installing SATAII hard disk to SATAII connector, please read the “SATAII

Hard Disk Setup Guide” on page 19 to adjust your SATAII hard disk drive to

SATAII mode. Besides, you are allowed to downgrade the SATAII hard disk to

SATA hard disk (from SATAII 3Gb/s down to SATA 1.5Gb/s), and connect it to

the SATAII connector. You can also connect SATA hard disk to SATAII connec-

tor directly.

Power Management for USB 2.0 works fine under Microsoft

Windows

SP1 or SP2 / 2000 SP4.

Although this motherboard offers stepless control, it is not recommended to

perform over-clocking. Frequencies other than the recommended CPU bus

frequencies may cause the instability of the system or damage the CPU.