IntraServer Technology ITI-90-100250 Manuel D’Utilisation
Page 72 of 83
Table 11: Adapter to Network Hub Wiring
Connection from the ITI-8241C-S adapter to another network adapter (point
to point) must be made as shown:
to point) must be made as shown:
Crossover
Adapter 1 Pin
Adapter 2
Pin
TX (+)
1
ßà
3
RX (+)
TX (-)
2
ßà
6
RX (-)
RX (+)
3
ßà
1
TX (+)
4
4
5
5
RX (-)
6
ßà
2
TX (-)
7
7
8
8
Table 12: Adapter to Adapter (point to point) Wiring
Network Cabling Requirements
In order for your network to operate properly, you must use a category of
network cabling that is appropriate for the data rate of the channel. For
10Mb/s operation, Category 3, or 5 cable is appropriate. When operating in
100Mb/s or 100Mb/s Full Duplex, a Category 5 cable should be used.
network cabling that is appropriate for the data rate of the channel. For
10Mb/s operation, Category 3, or 5 cable is appropriate. When operating in
100Mb/s or 100Mb/s Full Duplex, a Category 5 cable should be used.
The maximum cable segment length supported at 100Mb/sec speed, on
Category 5 cable is 100M. Any single cable segment (adapter to adapter or
adapter to network hub) must be within the 100M length requirement.
Category 5 cable is 100M. Any single cable segment (adapter to adapter or
adapter to network hub) must be within the 100M length requirement.