Intel SR1500AL Manuel D’Utilisation

43

1. Observe the safety and ESD precautions at the beginning of this book. See 

“Safety 

Information”

. 

2. Power down the server and unplug all peripheral devices and the AC power 

cable(s). 

3. Remove the front bezel if it is installed. For instructions, see 

“Removing the Front 

Bezel”

. 

4. Remove the server system cover. For instructions, see 

“Removing the System 

Cover”

. 

5. Insert the interposer board into the optical drive.

6. Obtain the optical drive and the drive tray.

7. Align the two holes on the left edge of the optical drive and interposer board with 

the two metal tabs in the tray as shown in 

Figure 34 

(see letter “A”).

8. Lower the opposite side of the optical drive into the tray until it clicks into place 

(see letter “B”).

9. Screw the interposer board into the carrier.

10. Insert the optical drive tray assembly into the server system as shown in 

Figure 35

.

11. Verify that the blue release lever on the tray locks into place.

12. Obtain the cable from the accessory kit and install the cable to the interposer board 

and the server board.

13. (Optional) For installing the optional USB floppy drive, note the location of the 

backplane USB connector and refer to the documentation that came with the 
device.

TP02147

A

B