iHome iHC5 Manuel D’Utilisation

1. The battery door is located on the back end of the remote.
2. Pull the battery door to release the battery door latch.
3.  Insert a CR2032 battery, checking that the + and – sides of the battery match the drawing 

inside the battery compartment. 

4. Replace the battery door into the remote control.

Note: Make sure you dispose of batteries properly (see your local regulations).

For best results, aim remote control towards the remote sensor on the lower left corner of 

the display.

 

The  iHC5  uses  a  backup  battery  system  (3  pre-installed  AA 
batteries) to provide continuous alarm operation and clock settings 
in  the  event  of  a  power  failure.  If  the  backup  battery  has  been 
installed and a power failure occurs or the AC cord is accidentally 
disconnected,  the  display  backlight  will  not  remain  lit,  but  current 
time  and  alarm  time  settings  will  be  temporarily  maintained. 
Otherwise, you must reset the time and alarm settings.
NOTE: Please make sure the AC adaptor is connected. Otherwise 

all settings may be lost during battery replacement.

1.  Open  the  backup  battery  compartment  door  located  on  the 

bottom of the unit.

2. Insert 3 AA batteries, checking that the polarity (+ and – ends of 

the battery) matches the drawing  near the battery compartment.

3. Close the compartment door.

Note: Make sure you dispose of batteries properly (see your local regulations).







P10