Hitachi SA200 Manuel D’Utilisation

Follow these instructions to connect a printer:

Locate the parallel port at the rear of your laptop. Refer 
to Figure 3 on page 7.

Connect the printer’s 25-pin male connector to the 
parallel port at the rear of your laptop.

If necessary, attach the printer cable to your printer. 
Tighten any retaining screws.

Turn on the printer and any other peripheral devices you 
have connected to the laptop.

If necessary, run the BIOS Setup program to configure 
the parallel port to properly respond to your system. 

Configure your printer in Windows 95. Refer to both 
your Windows 95 documentation and your printer 
documentation for detailed information.

You can connect peripheral devices that meet USB specifications 
to your SA200. 

Follow these steps to connect a USB device:

Locate the USB port on the rear of your laptop. Refer to 
Figure 4 on page 8 for details.

Connect the USB cable to the USB port.

Connect the other end of the USB cable to your USB 
device.

Follow the instructions provided with the device for 
configuration and usage. If your laptop is turned off, turn 
it on.

lonestar.boo : sa200.fm  Page 49  Friday, March 6, 1998  10:53 AM