Hamilton Beach Water System SA-HB-40-DB-CERT Manuel D’Utilisation
2 | Hamilton Beach Owner’s Manual
Hamilton Beach Owner’s Manual | 3
MODEL:
SA-HB-40-DB-CERT Water Softener
Operating Temperature:
34
o
–120
o
F
Operating Pressure:
20–60 psi (#5 injector); 61-120 psi (#4 injector)
Voltage:
110V 60 cycles
Rated Service Flow:
15.2 GPM @ 15 psi
Rated Softening Capacity:
14.2 @ 3.0 (#5 injector)
(Kilograins / Pounds of Salt)
24 @ 7.5, 37.0 @ 15 (#4 injector)
Max Flow Rate to Drain:
4.0 GPM
Amount of High Capacity Resin:
1.25 ft
3
Rated Efficiency:
4,720 grains @ 3.0 lbs
**Observe all state and local plumbing codes.
**This softener conforms to NSF/ANSI 44 for the specifically claimed
performance.
**The efficiency of the softener is valid only at the stated salt
dosage.
Manufactured By:
R&M Manufacturing
28 South 1550 West
Lindon UT 84042-1617
(801) 785-5557
pn: LBL-HB-40-CERT
CAUTION: Do NOT use with water that
is microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system.
pn: LBL-HB-48-CERT
MODEL:
SA-HB-48-CERT Water Softener
Operating Temperature:
34
o
–120
o
F
Operating Pressure:
20–60 psi (#5 injector); 61-120 psi (#4 injector)
Voltage:
110V 60 cycles
Rated Service Flow:
18 GPM @ 35 psi inlet
Rated Softening Capacity:
15.1 @ 3.6 (#5 injector)
(Kilograins / Pounds of Salt)
26.0 @ 9.0, 39.7 @ 18 (#4 injector)
Max Flow Rate to Drain:
3.5 GPM
Amount of High Capacity Resin:
1.5 ft
3
Rated Efficiency:
4,210 grains @ 3.6 lbs
**Observe all state and local plumbing codes.
**This softener conforms to NSF/ANSI 44 for the specifically claimed
performance.
**The efficiency of the softener is valid only at the stated salt dosage.
Manufactured By:
R&M Manufacturing
28 South 1550 West
Lindon UT 84042-1617
(801) 785-5557
CAUTION: Do NOT use with water that
is microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system.
See pages 8 through 11 for:
• pre-installation checklist
• installation instructions
• start-up directions