Grandstream Networks TV Converter Box HT386 Manuel D’Utilisation

 

Grandstream Networks, Inc. 

Page 13 of 34  

 

NOTE:   “Enable Call Feature” must be set to “Yes” in web configuration page. 
Caller A can place a call on hold and wait for one of three situations:   
 

1.  A quick confirmation tone (similar to call waiting tone) followed by a dial tone.  This indicates the 

transfer is successful (transferee has received a 200 OK from transfer target).  At this point, 
Caller A can either hang up or make another call.  

2.  A quick busy tone followed by a restored call (on supported platforms only).  This means the 

transferee has received a 4xx response for the INVITE and we will try to recover the call.  The 
busy tone is just to indicate to the transferor that the transfer has failed.  

3.  Continuous busy tone.  The phone has timed out. Note:  continuous busy tone does not indicate 

the transfer has been successful, nor does it indicate the transfer has failed.  It often means there 
was a failure to receive second NOTIFY – check firmware for most recent release.  

Assume that Caller A and B are in conversation. Caller A wants to Attend Transfer B to C: 

1. Caller 

A 

presses 

FLASH on the analog phone for dial tone. 

2.  Caller A then dials Caller C’s number followed by # (or wait for 4 seconds). 

3.  If Caller C answers the call, Caller A and Caller C are in conversation. Then A can hang up to 

complete transfer. 

4.  If Caller C does not answer the call, Caller A can press “flash” to resume call with Caller B.  

 
NOTE:  When Attended Transfer fails and A hangs up, the HT-502 will ring back user A to remind A that 
B is still on the call.  A can pick up the phone to resume conversation with B. 

Star Code Style 3-way Conference 
 
Assuming that call party A and B are in conversation. A wants to bring C in a conference: 
 

1.  A presses FLASH (on the analog phone, or Hook Flash for old model phones) to get a dial tone. 
2.  A dials *23 then C’s number then # (or wait for 4 seconds).  
3.  If C answers the call, then A press “flash” to bring B, C in the conference. 
4.  If C does not answer the call, A can press “flash” back to talk to B.  

 

Bellcore Style 3-way Conference 
 
Bellcore style 3-way conference is also supported. To do this, user needs to enable “Use Bell-style 3-way 
Conference” in FXS1 or FXS2 web configuration. 
 
Assuming that call party A and B are in conversation. A wants to bring C in a conference: 
 

1.  A presses FLASH (on the analog phone, or Hook Flash for old model phones) to get a dial 

tone. 

2.  A dials C’s number then # (or wait for 4 seconds).  
3.  If C answers the call, then A press “flash” to bring B, C in the conference. 
4.  If C does not answer the call, A can press “flash” back to talk to B.