Graham Field NEB-U-TYKE JB0112-164 Manuel D’Utilisation
John Bunn Neb-u-Tyke RR Train Nebulizer Compressor 7
SET-UP
Note: Before initial operation, clean the nebulizer cup as-
sembly following the instructions given in
Note: Before initial operation, clean the nebulizer cup as-
sembly following the instructions given in
MAINTENANCE/
Cleaning the Nebulizer Cup.
WARNING: Ensure that the nebulizer compressor is un-
plugged during set-up.
plugged during set-up.
1. Before each use, inspect the compressor and nebulizer
cup assembly for damage or wear; replace as needed.
2. Place the compressor on a table or other flat stable sur-
face (not on the floor), in an area that is clean and dust-
free. Be sure you can easily reach the controls when
seated.
free. Be sure you can easily reach the controls when
seated.
3. Open the nebulizer medication cup: Twist the cap coun-
ter-clockwise until it stops, then lift cap off.
4. Pour the prescribed medication into the nebulizer medi-
cation cup. Do not fill with more than 5 ml per treat-
ment.
ment.
5. Install cap on cup. Turn clockwise to
tighten.
6. If using the mouthpiece for treatment,
proceed to step 7. If using a mask,
install the bottom part of the mask
directly onto the top of the nebulizer
medication cup cap as shown at right.
Proceed to step 9.
install the bottom part of the mask
directly onto the top of the nebulizer
medication cup cap as shown at right.
Proceed to step 9.
7. Insert mouthpiece into large end of
T adapter.
install cap
on cup
cap
cup
install mask
on cap
mask
cap
assemble
mouthpiece
and T adapter
T adapter
mouthpiece