Escient MP-100 Manuel D’Utilisation

P

AGE

 141

F

IRE

B

ALL

-MP I

NSTALLATION

 & U

SER

’

S

 G

UIDE

 - M22002-01A1

A

PPENDIX

 H - R

EMOTE

 C

ONTROL

 

       If the LED did not blink twice, then repeat steps 2 through 3 and try entering the 

same code again.

4.    Aim the Remote at the component and press PWR once. It should turn off. If it does 

not respond, repeat steps 2-3, trying each code for your brand until you find one that 
works. If the device does not have a PWR key, press PLAY. 

5.    Repeat steps 1 through 4 for each component you want the Remote to control.  

1.    Turn on the TV/VCR Combo and insert a video cassette. NOTE: Please read steps 

2-4 completely before proceeding. We recommend highlighting or writing down the 
code for the brand you wish to program before moving onto step 2. 

2.    On the Remote, press DVD. Press and hold CODE SET until the LED blinks twice, 

then release CODE SET. 

3.    Use the Setup Codes For TV/VCR Combos (last section in this appendix) to locate 

the brand name and then enter the first four-digit code for your component. If 
performed correctly, the LED will blink twice. NOTE: If the LED did not blink 
twice, then repeat steps 2 through 3 and try entering the same code again. 

4.    Aim the Remote at the component and press PWR once. It should turn off. If it does 

not respond, repeat steps 2-3, trying each code for your brand until you find one that 
works. If it still does not work, try searching for the code (see Searching For Your 
Code). NOTE: If the device does not have a PWR key, press PLAY. 

5.    If you’ve located a setup code that works, but it has a separate TV code, you’ll also 

need to program it into the Remote to access volume control as follows: