Epson BrightLink Solo Interactive Module (IU-01) Guide D’Installation Rapide
14
Mounting the Interactive Module
Before you mount the interactive module, note the serial number on the arm. Write it down on page 18 of
this guide so you can refer to it in case you need product support.
this guide so you can refer to it in case you need product support.
1
Attach the interactive module onto the wall plate and position the USB cable as shown. You can pass
the cable through the left or right side. Make sure the cable doesn’t get trapped when you mount the
module on the wall plate.
the cable through the left or right side. Make sure the cable doesn’t get trapped when you mount the
module on the wall plate.
2
Secure the interactive module to the wall plate with the two included bolts, using the included
hexagonal wrench. Do not tighten the bolts completely until you center the interactive module over
your image area.
hexagonal wrench. Do not tighten the bolts completely until you center the interactive module over
your image area.
3
If you installed the long wall plate, slide the arm horizontally to position the interactive module above
the center of the projection area or whiteboard.
the center of the projection area or whiteboard.
4
Tighten the bolts using the included hexagonal wrench.