Epson BrightLink Pro 1410Wi Meeting Room Productivity Tool with Wall Mount Guide De Montage
49
English
8 Installing the Touch Unit
The following procedures must have been completed before installing the Touch Unit:
•
Installing the projector (see page 30)
•
Adjusting the projected image (see page 41)
•
Calibrating the interactive pen(s)
s
Refer to your projector User's Guide or Start Here folder for detailed instructions.
Follow the steps below to install the Touch Unit and connect to the projector. Some menus may differ slightly
from the illustrations, but the installation instructions are the same.
from the illustrations, but the installation instructions are the same.
A
Turn on the projector
B
Display the installation pattern
1. Select Easy Interactive Function from the Extended menu.
❏
There are magnets built in to the back of the Touch Unit. Typically, the Touch Unit
should be installed by attaching the magnets to the screen or whiteboard.
should be installed by attaching the magnets to the screen or whiteboard.
❏
If the magnets cannot be attached, use commercially available M4 screws (×3).
❏
Install the Touch Unit on a flat, smooth, unwarped surface that is the same level
surface as the screen surface. If there is unevenness on the screen surface of more
than 0.2 inches (5 mm) in any direction, your fingers may not be detected and
finger touch operations may not be performed correctly.
surface as the screen surface. If there is unevenness on the screen surface of more
than 0.2 inches (5 mm) in any direction, your fingers may not be detected and
finger touch operations may not be performed correctly.
Using the Remote Control
BrightLink 595Wi/595Wi+
BrightLink 595Wi/595Wi+
Using the Remote Control
BrightLink Pro 1430Wi
Using the Control Panel
The Touch Unit should only be connected to the BrightLink 595Wi/595Wi+ or BrightLink Pro
1430Wi models. Do not connect the Touch Unit to any other projectors or devices.
1430Wi models. Do not connect the Touch Unit to any other projectors or devices.
Caution