Emulex Computer Drive 355 Manuel D’Utilisation
I
N
S
PEED
™ SAN S
TORAGE
S
WITCH
M
ODEL
355
C
HAPTER
3 S
WITCH
M
ANAGEMENT
U
SER
’
S
G
UIDE
44
Automatic Trunking
Multiple links between switches are called “trunks”. Trunks provide higher bandwidth across cascaded
switches for systems incorporating multiple initiators. Each trunk can improve system throughput and
provide “failover” capability. A maximum of 4 trunks between each switch is supported. Trunking is
performed automatically when ports are configured properly. Figure 3-22 is an example of Automatic
Trunking.
switches for systems incorporating multiple initiators. Each trunk can improve system throughput and
provide “failover” capability. A maximum of 4 trunks between each switch is supported. Trunking is
performed automatically when ports are configured properly. Figure 3-22 is an example of Automatic
Trunking.
Each trunk is part of a trunk group. A trunk group consists of two or more cascades between two
switches. There can only be one trunk group between two switches. Each trunk group contains a
primary trunk. All traffic flows through the primary trunk on a switch unless specified otherwise using the
Load Balancing feature. The primary trunk is always the lowest numbered port of any trunk group.
switches. There can only be one trunk group between two switches. Each trunk group contains a
primary trunk. All traffic flows through the primary trunk on a switch unless specified otherwise using the
Load Balancing feature. The primary trunk is always the lowest numbered port of any trunk group.
If the primary trunk fails, the secondary trunk automatically becomes the primary trunk unless otherwise
configured. Multiple cascades also enable switch configuration for better performance through load
balancing (see “Load Balancing” on page 45).
configured. Multiple cascades also enable switch configuration for better performance through load
balancing (see “Load Balancing” on page 45).
The Automatic Trunking page enables users to configure trunking by defining trunk groups and
assigning ports to those groups. The Automatic Trunking feature is available when one or more ports are
assigned a String or Tree Cascade Smart Setting.
assigning ports to those groups. The Automatic Trunking feature is available when one or more ports are
assigned a String or Tree Cascade Smart Setting.
To configure Automatic Trunking:
1.
Click Advanced Functions > Automatic Trunking.
The Automatic Trunking page appears.
2.
Select a trunk group for each port by clicking the appropriate Trunk Group option.
3.
When finished making changes, click Submit.
Figure 3-22: Automatic Trunking example
Figure 3-23: Advanced Functions: Automatic Trunking page