Emerson Liebert MC Microchannel Outdoor Condenser 28 - 220kW Manuel D’Utilisation

4. Lift the unit 24" (610mm) off the top deck of the skid.
5. Move the skid from under the unit.
6. A mechanized method is preferred, but if not available, uses a minimum of four properly protected 

individuals to turn the unit upright so that the legs point down.
Unit legs must be pointing toward the ground.

7. Set the upright unit on the ground so the legs support unit weight.
8. Remove the straps from around unit.
9. One-fan and two-fan units: Route the straps through the large holes in the side of the legs. 

Spreader bars are still required.

On three-fan and four-fan units: Secure straps or chains to the eyebolts on top of the unit. 

Spreader bars are still required.

Risk of improper lifting. Can cause equipment damage.
Make sure that the spreader bars wider are than the unit. If the spreader bars are too short, 

the slings may crush the unit.

The unit is ready to be lifted and moved to its installation location.