Emerson SS-100 Manuel D’Utilisation
4 • SS-100 HALComm and UltraSite Wiring Layouts
3
Configuring the
SS-100
1.
2.
Connect the SS-100 to the LAN and power up the
unit.
unit.
3.
Open EZWebCon on your computer (which must
also be connected to the LAN) and click the bin-
oculars icon (outlined in red) to find the allocated
IP address of the SS-100:
also be connected to the LAN) and click the bin-
oculars icon (outlined in red) to find the allocated
IP address of the SS-100:
4.
Choose the correct device on the Browse Net-
work screen and then click Ok:
work screen and then click Ok:
5.
Verify that the firmware version number in the
"Firmware" column is "3.6/9". If the firmware
version shows any other number than "3.6/9," the
SS-100 is the wrong version; contact Technical
Service for instructions on upgrading.
If the Firmware version is correct, proceed to
step 6.
"Firmware" column is "3.6/9". If the firmware
version shows any other number than "3.6/9," the
SS-100 is the wrong version; contact Technical
Service for instructions on upgrading.
If the Firmware version is correct, proceed to
step 6.
6.
Highlight the device and select Action>Manage
from the drop-down menu to open the Home
screen:
from the drop-down menu to open the Home
screen:
7.
When any of the links along the left-hand side of
the screen are clicked the first time, you are
prompted to the Password screen: enter the pass-
the screen are clicked the first time, you are
prompted to the Password screen: enter the pass-
Device Configurator (Search Tool Outlined)
NOTE: A search will locate all SS-100s on the
network. Use the MAC address located on the
back of the SS-100 to find the correct SS-100
network. Use the MAC address located on the
back of the SS-100 to find the correct SS-100
in the list.
Choose and Highlight the Device
Action Menu Displayed