Emerson Avocent HMX Digital High Performance KVM Switch Guide De Montage
Chapter 2: Installation 21
NOTE: Use only the power supply provided by Avocent.
To connect power to the user station and transmitter:
1. Plug the external power supply’s 2.5mm connector into the DC power jack on the rear of the
user station and transmitters.
2. Connect the detachable IEC power cord to the power supply.
3. Plug the IEC power cord into an appropriate wall outlet.
3. Plug the IEC power cord into an appropriate wall outlet.
Networked installation
The following instructions will enable you to install your user station and transmitter in a
networked configuration. In this installation, multiple transmitters and user stations are attached via
the same Ethernet network. In this case, it is important for each unit to be configured with a unique
IP address.
networked configuration. In this installation, multiple transmitters and user stations are attached via
the same Ethernet network. In this case, it is important for each unit to be configured with a unique
IP address.
NOTE: In Desktop and Extender modes, the HMX 1070 and HMX 2050 user station and HMIQSHDI and
HMIQDHDD transmitter can obtain their IP address data from a DHCP server.
HMIQDHDD transmitter can obtain their IP address data from a DHCP server.
Transmitters and user stations may be configured for use on a single subnet or for use across
routers. Use of routers, however, will cause a slight increase in end-to-end latencies, which may not
be acceptable for all applications.
routers. Use of routers, however, will cause a slight increase in end-to-end latencies, which may not
be acceptable for all applications.