Guardian Technologies Guardian Technologies, LLC Home Security System DVST Manuel D’Utilisation
8.4
ASCOM 5000 / CITAM
ATMODE
Cables required - 2x 15 to 15 (Part No. AS-DVST-X21). Dip switch settings can be used
and should be set as follows:
and should be set as follows:
Note:
Switch 3 selects the sub address, if used.
Step
Instruction
Remarks
1
Using the pull handle, remove the
circuit board module from the Citam
5000
circuit board module from the Citam
5000
2
Adjust the dip switches as shown in
Figure 9
Figure 9
The Citam will now perform a self test.
On completion the display will read
ISDN.
ISDN.
3
Press the select key four times so
that the legend ‘CONF’ appears on
the display.
that the legend ‘CONF’ appears on
the display.
4
Press the enter key once and it will
say ‘PRT1’, press the select key
twice it will say ‘TA’ , press the enter
key it will say ‘SHOW’.
say ‘PRT1’, press the select key
twice it will say ‘TA’ , press the enter
key it will say ‘SHOW’.
5
Press and hold select until the
display reads ‘CHNG’, remove your
finger from the select key and press
t h e e n t e r k e y , ‘ I N D B ’ w i l l b e
displayed.
display reads ‘CHNG’, remove your
finger from the select key and press
t h e e n t e r k e y , ‘ I N D B ’ w i l l b e
displayed.
6
Press the enter key, the message will
be ‘ON’, use the select key to turn
this to ‘OFF’, then press the enter
key.
be ‘ON’, use the select key to turn
this to ‘OFF’, then press the enter
key.
7
Hold the select key and press the
enter key, the display will return to
‘CONF’.
enter key, the display will return to
‘CONF’.
This has turned of the in-band test
feature of the unit.
feature of the unit.
8
At ‘CONF’ press the enter key, the
display will read ‘PRT1’ for port 1.
display will read ‘PRT1’ for port 1.
Page 34
Dedicated Micros Ltd
Terminal Adapters
DVST Installation Guide
Fig 5: ASCOM internal dip switch settings (ATMODE)