Craftsman CM 14 INCH CHOP SAW Manuel Du Propriétaire
22
23
22
23
SYMPTOM
POSSIBLE CAUSES
CORRECTIVE ACTION
Chop saw wheel hits
base or work surface.
1. The cutting depth
adjustment bolt is set
too deep.
1. See “Adjusting the
Cutting Depth Stop
Bolt” section.
Cutting wheel does not
cut through workpiece.
1. Depth stop bolt setting is
incorrect.
1. See “Adjusting the
Cutting Depth Stop
Bolt” section.
Cut is not square.
1. Defective wheel.
2. Work not positioned
properly.
3. Excessive wheel
pressure.
1. Replace immediately.
2. See “Adjusting for
Angle Cutting” section.
3. Lessen wheel pressure
during cutting operation.
Chop saw wheel binds,
jams, burns workpiece.
Rough cuts.
1. Improper operation.
2. Dull chop saw wheel.
3. Improper chop saw
wheel.
1. See “Operation”
section.
2. Replace wheel.
3. Replace with 14 in.
abrasive cutting wheel.
Tool vibrates or
shakes.
1. Wheel not round.
2. Wheel damaged.
3. Wheel loose.
4. Machine is not secure.
5. Other.
1. Replace wheel.
2. Replace wheel.
3. Tighten arbor bolt.
4. Mount tool to
worksurface.
5. Call customer service.
Power head won’t
fully rise.
1. Pivot spring not replaced
properly after service.
2. Part failure.
1. Call customer service.
2. Call customer service.
Cutting head hard to
pull/push down.
1. Lubrication needed.
1. See “Maintenance”
section.
To avoid injury from accidental starting, always turn the switch OFF and unplug the
tool before moving, replacing the abrasive cutting wheel or making adjustments.
TROUBLESHOOTING GUIDE
WARNING
!