Fujitsu 2300 Manuel D’Utilisation

Removing and Installing the Battery Pack

• The Stylistic 2300 battery pack uses lithium ion battery cells which have no 

“memory effect.” You do not need to discharge the battery pack before you begin 
charging. 

Removing and Installing the Battery Pack

2

The battery pack can be removed from the pen tablet and swapped with a charged 
battery pack. The battery pack can then be charged in an external charger if one is 
available. To remove the battery pack from the pen tablet: 

1. Choose one of the following: 

• If a charged battery pack is available, you can suspend system operation. A 

built-in “bridge” battery will maintain the system in Suspend-to-RAM mode 
for about 5 minutes while the battery pack is removed.

• If a charged battery pack is not available, save your work and close all 

running programs, then shut down the system.

• Plug in an external DC power source.

2. Slide the battery latch to the unlocked position. (See Figure 2-3.)

3. Slide the battery pack out of the pen tablet. 

If you are using an external battery charger, refer to the instructions provided with 
the battery charger. 

To install the battery pack:

1. Slide the battery pack into the pen tablet until it is firmly seated.  

2. Slide the battery latch into the locked position. 

Once the battery pack is installed, you can resume system operation or start your 
system and use the system as you normally would. 

Keep your fingers clear of the area between the battery pack 
and the pen tablet when you install the battery pack.