Compex Technologies NetPassage 15B Manuel D’Utilisation

Appendix A Console Commands

44

forwarding. You may obtain the <INDEX> by listing the defined IP
forwarding table with the command “SHOW IP STATIC NAT TABLE”

DELETE PORT STATIC NAT <INDEX>

Delete an entry from the list of defined virtual server based on port
forwarding. You may obtain the <INDEX> by listing the defined port
forwarding table with the command “SHOW PORT STATIC NAT
TABLE”

DELETE DHCP RESERVE <INDEX>

Delete a DHCP reservation from the list. The <INDEX> is the sequence
from top by listing the DHCP reservation table with the command
“SHOW DHCP RESERVE”

DELETE FILTER <INDEX>

Delete an IP packet filtering rule. You may obtain the <INDEX> by
listing the defined IP filtering rule with the command “SHOW FILTER”

RESET Command

RESET SYSTEM

Reboot the router

RESET CONFIG

Reset the configuration back to factory defaults

ADD Command

ADD IP ROUTE <DES> <GATEWAY>

Add an entry to the routing table

ADD IP STATIC NAT <PRI IP> <PUB IP>

Add a virtual server based on IP forwarding

ADD PORT STATIC NAT <PRI IP>
<TCP/UDP> <FROM PORT> <TO PORT>
“<RULE NAME>”

Add a virtual server based on Port Forwarding

ADD DHCP RESERVE <PRIV IP> “<HOST
NAME>” <MAC ADDR>

Add a DHCP reservation

ADD FILTER

Add a IP packet filtering rule

ENABLE Command

ENABLE RIP <VERSION>

Enable RIP version 1 or 2

ENABLE NAT

Enable Network Address Translator

ENABLE DHCP SERVER

Enable DHCP server

DISABLE Command

DISABLE RIP

Disable RIP

DISABLE NAT

Disable Network Address Translator

DISABLE DHCP SERVER

Disable DHCP server

SAVE Command

SAVE CONFIG

Save the changes in configuration to the router’s flash ROM

DISCONNECT Command

DISCONNECT TELNET SESSION

Disconnect from the TELNET console management

EDIT Command

EDIT FILTER <INDEX>

Edit a defined IP packet filtering rule