Citizen Systems Network Router 1.8 Manuel D’Utilisation
CITIZEN OPOS DRIVER 1.8 Application Development Guide
44
SetBitmap Method/ESC|#B Escape Sequence
Bitmap is registered by specifying Bitmap number (1 - 20) using the SetBitmap method and
bitmap printing is carried out by specifying the registered number in the ESC|#B escape
sequence. This driver has two modes, raster bit image mode and NV bit image mode.
Specification of each mode is as shown below.
・
bitmap printing is carried out by specifying the registered number in the ESC|#B escape
sequence. This driver has two modes, raster bit image mode and NV bit image mode.
Specification of each mode is as shown below.
・
Raster bit image mode
SO stores own bitmap using the SetBitmap method. When SO is closed, the stored bitmap is
cleared. Therefore, it is necessary to register bitmap each time SO is opened.
cleared. Therefore, it is necessary to register bitmap each time SO is opened.
・
NV bit image mode
Using the SetBitmap method, SO writes bitmap to the nonvolatile memory (Flash ROM) of the
printer.
Therefore, it is not necessary to register bitmap each time SO is opened.
The initial value of this driver is raster bit image mode. To change to the NV bit image mode,
perform the following registry operation.
<Example: CT-S2000>
perform the following registry operation.
<Example: CT-S2000>
HKEY_LOCAL_MACHINE¥SOFTWARE¥OLEforRetail¥ServiceOPOS¥POSPrinter¥CT-S2000_1
UseNVRAM = 001 ･･･ NV bit image mode
UseNVRAM = 000 ･･･ Raster bit image mode (initial value)
* When changing the above setting, use the setting tool of this driver (Configuration Utility) as
UseNVRAM = 001 ･･･ NV bit image mode
UseNVRAM = 000 ･･･ Raster bit image mode (initial value)
* When changing the above setting, use the setting tool of this driver (Configuration Utility) as
explained in “1.6 Registry Structure”.
(Configuration Utility)
The time required for write operation in NV bit image mode depends on the communication
condition, printer performance, etc. When writing bitmap registration is unsuccessful, conduct a
test after setting the registry value of the following transmission timeout time to 10,000 ms or
more.
condition, printer performance, etc. When writing bitmap registration is unsuccessful, conduct a
test after setting the registry value of the following transmission timeout time to 10,000 ms or
more.
<Example: CT-S2000>
HKEY_LOCAL_MACHINE¥SOFTWARE¥OLEforRetail¥ServiceOPOS¥POSPrinter¥CT-S2000_1
WriteTimeout：10000 or more ・・・ 5000 (Initial value)
* When changing the above setting, use the setting tool of this driver (Configuration Utility) as
WriteTimeout：10000 or more ・・・ 5000 (Initial value)
* When changing the above setting, use the setting tool of this driver (Configuration Utility) as
explained in “1.6 Registry Structure”.
(Configuration Utility)
* To insure long life of the printer, registration of NV bitmap shall be less than 10 times/day.