Cisco Systems 3527 PRI Guide De Montage

  

 shows the rear panel components of the Cisco Unified Videoconferencing 3522 BRI Gateway 

unit. 

 describes these components.

  

These are the requirements for installing the Cisco Unified Videoconferencing 3527 PRI Gateway unit.

Proper clearance at the sides of the unit to allow adequate ventilation, and at least 20 cm clearance 
at the back of the unit to allow access to cable connections

A PC with a serial port and terminal emulation software to assign the Cisco Unified 
Videoconferencing 3527 PRI Gateway unit an IP address

Dedicated IP address for the Cisco Unified Videoconferencing 3527 PRI Gateway unit

ACT LED

Lights green to indicate that there are active calls in the gateway.

D-Ch LED

Lights green to indicate that the PRI line is enabled and a carrier signal is 
detected.

ALARM LED

Displays alarm events for the PRI line. 

YELLOW —Lights yellow when there is a loss of frame alignment at 
the remote side. 

ORANGE—Lights orange when there is a loss of frame alignment in the 
gateway. 

PRI LINE connector

RJ-45 connector that provides the PRI line connection for the gateway ISDN 
PRI port. 

ACT LEDs

Lights green to indicate that there are active calls in the gateway on the 
specified BRI line.

BRI LINE connectors

RJ-45 connectors that provide the BRI line connections for the specified 
gateway ISDN BRI port. 

BRI-1

4

3

2

ACT

1

BRI-2

BRI-3

BRI-4

157262