Cisco Systems 2.7 Manuel D’Utilisation

Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19

Setting Up IOS Access Points

5-18

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

78-16345-01

Using a Wireless LAN Services Module (WSM) as the WDS Device

If you are using a WSM to provide WDS, instead of using APs for WDS, follow
the procedures in the WSM documentation to configure it for WDS. Use the IP
address of the WLSE as the WNM IP address.

Configuring Infrastructure Access Points to Register with WDS Access Points

Infrastructure access points initiate participation in SWAN by registering and
LEAP authenticating with the WDS.

The only required configuration for infrastructure access points is the username
and password used to register with the WDS.

There are three ways to configure infrastructure access points to register with
WDS:

•

Using the access point web interface—See

Using the Web Interface to

Configure Infrastructure APs, page 5-18

•

Using the access point CLI interface—See

Using the Command Line

Interface to Configure Infrastructure APs, page 5-19

•

Using a WLSE configuration template—See

Using a WLSE Configuration

Job to Configure Infrastructure APs, page 5-19

Using the Web Interface to Configure Infrastructure APs

To use the web-based interface to configure infrastructure APs:

Step 1

Step 2

Select Wireless Services > AP.

Step 3

Select Enabled.

Step 4

Enter the username and password for authenticating the infrastructure AP to the
WDS.

Step 5

Click Apply.