Ciprico Rimfire 3880 Manuel D’Utilisation
21020285 D
User’s Guide
Chapter 6 Target Mode Pass-through Commands
Page 6 - 2
Introduction
Introduction
With the RF3880 you have the option to use the adapter as a target on the SCSI
bus. The RF3880 may operate as a target, as an initiator, or as both a target and
an initiator at the same time.
bus. The RF3880 may operate as a target, as an initiator, or as both a target and
an initiator at the same time.
When in Target Mode, the RF3880 can be used to emulate any of the defined
SCSI peripheral device types.
SCSI peripheral device types.
As an initiator the RF3880 receives two types of commands: Board-level and
Pass-through. This is also true when it is operating as a target.
Pass-through. This is also true when it is operating as a target.
Summary
This chapter explains how to setup the Target Mode feature of the RF3880 and
describes the following aspects of its use:
describes the following aspects of its use:
•
Command and status implementation.
•
Command operation.
•
Sequence of operation.
This chapter is useful to use to understand the Target Mode of the RF3880.