Ciprico Rimfire 3880 Manuel D’Utilisation

The Stop Command List command is used to gracefully halt Command List 
operations. Upon receipt of this command, the adapter will accept no further 
additions to the Command List queue. 

After all other existent commands are executed from the Command List, a 
Status Block for this command is returned.

The Stop Command List command is useful when you are shutting down your 
system. It processes and returns status of commands current at the time of its 
issue, therefore you can be sure all data is transferred properly before shutdown.

This command should be issued via a Single Command Structure.

The format of the Stop Command List Parameter Block is shown below:

Each of the fields used by the Stop Command List command are explained 

in the following section:

The Command Identifier field is used to identify the Status Block associated 
with a Parameter Block. It must be a unique value.

The Stop Command List command is a Board-control command. To identify 
it as such to the RF3880 adapter, this field must contain the value FFH.

Note
An error code of 11H 
will be returned in the 
Status Block for this 
command if you attempt 
to stop a Command List 
that is stopped (or has not 
been started).

The command code to use to indicate the Stop Command List command is 02H.

Address 

Offset

Byte Memory Address

Offset + 0

Offset + 1

Offset + 2

Offset + 3

00H

Command Identifier

04H

Reserved

Adapter ID = FFH

08H

Reserved

0CH

Reserved

10H

Command = 02H

Reserved

14H

Reserved

18H

Reserved