Ciprico Rimfire 3880 Manuel D’Utilisation
User’s Guide
21020285 D
Chapter 3 Hardware Installation
Step 5: Configure and Connect SCSI Devices
Page 3 - 15
resistors installed. If termination is not correctly applied to the bus, data
corruption can occur. If you are using only two devices on the bus (the RF3880
and one peripheral) both must be terminated. If you are using multiple devices
on the SCSI bus (several peripherals, in addition to the RF3880 adapter) only
the two devices physically at the ends of the cable must be terminated.
corruption can occur. If you are using only two devices on the bus (the RF3880
and one peripheral) both must be terminated. If you are using multiple devices
on the SCSI bus (several peripherals, in addition to the RF3880 adapter) only
the two devices physically at the ends of the cable must be terminated.
Cabling
The SCSI cable connector for the RF3880 extends from the front faceplate.
Currently there is one model of the RF3880, and it uses a SCSI “P” type
connector to implement the differential interface.
Currently there is one model of the RF3880, and it uses a SCSI “P” type
connector to implement the differential interface.
Model
SCSI mode
Max Cable Length
SCSI Connector
RF3886
Differential
25 meters (82 ft.)
68 pin ‘P’ connector
Table 16: SCSI Cable Connector