Chicago Electric 96531 Manuel D’Utilisation
Page 13
SKU 96531
For technical questions, please call 1-800-444-3353.
(4), and unplug the tool from its electrical outlet before
performing inspection, maintenance, or cleaning procedures.
Damaged equipment can fail, causing personal injury. Do
Damaged equipment can fail, causing personal injury. Do
not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, maintenance, and lubrication
beFore each use, inspect the general condition of the tool. Check for dam-
aged Soldering Iron (15) tip, loose screws, cracked or broken parts, damaged
electrical wiring, and any other condition that may affect its safe operation.
aFter use, clean external surfaces and Soldering Tip.
Warning! if the supply cord of this power tool is damaged, it must be
aFter use, clean external surfaces and Soldering Tip.
Warning! if the supply cord of this power tool is damaged, it must be
replaced only by a qualified service technician.
replacing the soldering iron
If Soldering Tip cracks or becomes eroded it must be replaced. The Soldering
Tip cannot heat up properly when cracked or eroded.
heating contact (17)
soldering iron (15)
tip retainer (16)
Turn Power Switch (4) to the “OFF” position and unplug the Soldering Station
from the electrical outlet. Allow adequate time for all surfaces to cool down.
Unscrew Tip retainer (16) that holds the Soldering Iron (15) onto the Heating
Unscrew Tip retainer (16) that holds the Soldering Iron (15) onto the Heating
Contact (17) and remove the Soldering Iron. It may be necessary to force the
Soldering Iron (15) out of the Tip retainer (16). To do this, place the Soldering
Iron on the side of the work bench, hold the Tip retainer, and push on it towards
the Soldering Tip, forcing it out. Be sure to wear ANSI-approved safety goggles
and heavy-duty work gloves while doing this.
Place new Solder Tip on Heating Contact, replace Retainer, and finger-tighten.
Place new Solder Tip on Heating Contact, replace Retainer, and finger-tighten.
replacing the Fuse
Turn the Power Switch (4) to the “OFF” position, unplug the Soldering Station
from the outlet, and allow time for all surfaces of the unit to cool down completely.
Turn the Soldering Station over and use a screwdriver to remove the cover
Turn the Soldering Station over and use a screwdriver to remove the cover
marked “FUSE” on the bottom.
remove the old fuse and replace with a new 6.3A/250V fuse of the same type.
remove the old fuse and replace with a new 6.3A/250V fuse of the same type.
replace cover and screw back into place.
1.
2.
3.
3.
1.
2.
3.
4.
1.
2.
3.