FARGO electronic HDP600 CR100 Manuel D’Utilisation

Page de 371
RESTRICTED USE ONLY 
 
Fargo Electronics, Inc. 
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 
15-2 
Glossary of Terms (continued) 
Term 
Definition 
Barcodes 
A series of alternating black and white stripes, of varying widths 
(each character denoted by a set number and width of black 
stripes) that allows characters to be optically read by a computer.  
batch print 
A file sent down from the computer that contains commands to 
print a number of cards, sequentially.  
Battery Back-up 
A power supply that can keep AC electronic equipment running 
for a short time when power is interrupted, allowing enough time 
for the user to save data and close the machine properly. 
Bi-directional 
A communication standard that allows two-way data transfer 
between PC and Printer.  
BIOS (Basic 
Input/Output System)  
The part of the operating system in a computer that handles 
communication between the PC mainBoard and its peripherals. 
Typically residing in chip-based, non-volatile memory.  
Bit 
An abbreviation for binary digital. Each bit is an element of 
information that can have two states: off and on. 
Bit map 
A graphic produced by an array of pixel elements with the color 
hue, brightness and saturation information stored in bits. The 
more bits, the more values and thus the greater variety. 1 bit color 
is black and white, 8-bit color produces 256 shades of gray and 
24-bit color can produce 16.7 million colors. 
Board 
A term used for the circuit Board, a hard mylar plate made of 
many layers, that holds the electronic circuit elements and wire 
traces. 
Boot-up 
A series of operations that the Printer runs through when power is 
first applied including a series of initializing, status testing and a 
diagnostics program to ensure a ready state. 
Buffer 
A block of memory, in the Printer or PC, that holds print files until 
the processor is ready to print them. 
Cable 
A set of conductors wrapped together and often concealed within 
insulation, used for signal transfer from one device to another, 
with connectors on either end that allows the cable to be 
removed. 
Continued on the next page