Chauvet DMX-800 Manuel D’Utilisation

Disconnect the power cord before replacing a fuse and always 
replace with the same type fuse. 

 

 

Disconnect the power cord before replacing a fuse and always 
replace with the same type fuse. 

 

 The fuse is located 
inside this 
compartment. 
Remove using a flat 
head screwdriver. 

FUSE 

ower.  

 

 need a serial data link to run light shows of one or more fixtures using a DMX-512 controller 

ber 

Important:  

Fixtures on a serial data link must be daisy chained in one single line. To comply with the EIA-485 

Maximum recommended serial data link distance: 500 meters (1640 ft.) 

es 

you must obtain data cables. You can purchase CHAUVET-certified DMX 

n 

en© 9841 or equivalent cable which meets the specifications for EIA RS-485 applications. 

With a flat-head screwdriver, unscrew the 

fuse holder from its housing. Remove the 

damaged fuse from its holder and replace 

with exact same type fuse. Screw the fuse 

holder back in its place and reconnect p

You will

or to run synchronized shows on two or more fixtures set to a master/slave operating mode. The 

combined number of channels required by all the fixtures on a serial data link determines the num

of fixtures the data link can support.  

standard no more than 32 devices should be connected on one data link. Connecting more than 32 
fixtures on one serial data link without the use of a DMX optically-isolated splitter may result in 
deterioration of the digital DMX signal.  

Maximum recommended number of fixtures on a serial data link: 32 fixtur

To link fixtures together 

cables directly from a dealer/distributor or construct your own cable. If you choose to create your ow

cable please use data-grade cables that can carry a high quality signal and are less prone to 

electromagnetic interference. 

Use a Beld

Standard microphone cables cannot transmit DMX data reliably over long distances. The cable will 

have the following characteristics: 

Constellation User Manual 

8 

2007-01-09/10:53