CarAlarms P90-NG1 Manuel D’Utilisation

Excalibur

®

 P90 Zero Clearance Direct Vent Gas Fireplace

17)  Reverse steps 4) to 2).

18)  Attach clear label "This unit has been 

converted to LPG" near or on top of the 
serial # decal.

19)  Replace yellow "Natural Gas" label with 

red "LPG" label.

14)  Using the Allen wrench as shown in 

Fig.4, rotate the screw clockwise until 
snug, do not overtighten.

)  Verify that if the conversion is from NG 

to LPG, the screw must be reassembled 
with the red o-ring visible (Fig. 5).

) Reassemble the black protection cap 

(Fig. 6).

are appropriate for the gas type. 

LPG Configuration

Red o-ring visible

1) 

Remove the control panel by unscrewing 
the 2 screws.

3) 

Plug up the Piezo hole with the plastic 
bushing.

4) 

Attach the DC sparker generator 
connector to the valve with a screw.

5) 

Remove the stove’s rear panel by unscrew-
ing the two screws.

6) 

Attach the ground wire to the grounding 
stud.

2) 

First, remove the Piezo Ignition Wire 
from the Piezo Ignitor. Then remove the 
Piezo Ignitor from the control panel.