Avital 5103 Manuel Du Propriétaire

Page de 40
©2009 Directed Electronics. All rights 
reserved.
6
Using your system 
 Active arming
You  can  arm  the  system  by  pressing
�������
on  your  trans mit ter  for  one  second. 
When the system arms, you will hear a short siren chirp and see the parking 
lights flash once. If the power door locks are con trolled by the system, the doors 
will also lock. While the sys tem is armed, the status LED will flash approximately 
once per sec ond, indicating that the system is actively pro tect ing your vehicle. 
Note: If you hear a second chirp after arming and note that the status LED is 
flashing in groups, see the Diagnostics Section of this guide. This extra chirp is 
called Bypass No ti fi ca tion.
 Passive arming
The system can be programmed to arm itself au to mat i cal ly (called pas sive arming). 
If the system is programmed for passive arming, it will automatically arm 30 seconds 
after the ignition is turned off and the system detects that you have left the vehicle by 
opening and closing a door. Whenever the system is in its 30-sec ond passive arm-
ing count down, the status LED will flash twice as fast as it does when the system 
is armed. At the 20-second point of the countdown, the siren will chirp to indicate 
that the system is about to arm. At the 30-second point, the parking lights will flash 
to indicate that the system is armed.
Important: If any protected entry point (such as a door or a 
switch-protected trunk or hood) is open, the system will not 
passively arm (unless forced Passive Arming is programmed 
on. See Programming Options section).
When armed your vehicle is protected as follows:
Light impacts trigger the Warn Away
®
 signal. When triggered, the siren 
chirps and the parking lights flash for a few seconds.
Heavy impacts trip a Triggered Sequence. The sequence consists of the 
siren sounding continuously and the parking lights flashing for a pre-pro-
grammed period, which can range in duration from 1 to 180 seconds.