Avocent Access Router Cyclades-PR2000 Manuel D’Utilisation

The parameter 

Send SAP Update can be set to Demand, Periodic, or None.  This parameter affects both SAP

and RIP.  

Periodic causes the router to send these messages every minute, while choosing Demand will cause

the router to send messages only when a message request is received.

Frame Relay parameters are explained in chapter 8.  The IPX-protocol-specific parameters are the same as
those described in the preceding section, but are located in the menu CONFIG =>INTERFACE
=><INTERFACE> =>ENCAPSULATION =>FRAME RELAY => <ESC> => ADD DLCI.

X.25 is explained in chapter 8.  The IPX-protocol-specific parameters are the same as those described in the
PPP section, but are located in the menu CONFIG =>INTERFACE =><INTERFACE> =>ENCAPSULATION
=>X25 => <ESC> => ADD DTE.

Routing can be done statically, by configuring static routes, or dynamically using RIP.  RIP is described in
chapter 9.  To create a static route, as shown in Figure 13.1, navigate to the menu CONFIG => STATIC
ROUTES => IPX =>ADD ROUTE.  The parameters for the system shown in the example are the following:

Add IPX Static Route Menu  CONFIG => STATIC ROUTES => IPX =>ADD ROUTE

Destination Network
Number

00010001

Interface

Slot 1

Next Hop Node

00602e001100

Number of Hops

1 (one router is between the router being configured and the network to be reached)

Number of Ticks

1 (related to the time necessary to reach the network)