Avaya Bogen Universal Paging Access Module Manuel De Montage
Procedure A
1.
Disconnect the UPAM from the telephone equipment.
2.
Confirm that the power supply is properly connected and that the MODE switches are in
the correct positions (make sure MODE switches S3 and S4 are not in the same
position). Note: If in station mode, connect the power supply.
the correct positions (make sure MODE switches S3 and S4 are not in the same
position). Note: If in station mode, connect the power supply.
3.
Connect a test set to T & R terminals on UPAM (test set should be on hook).
See Figure 11.
See Figure 11.
4.
Take test set off hook. If the UPAM activates and you can make a page, the UPAM and
paging system are functioning correctly. The problem must be with the voice switch or
interface wiring.
paging system are functioning correctly. The problem must be with the voice switch or
interface wiring.
If the UPAM does not activate, contact Technical Support.
If the UPAM activates, but paging is not possible, perform Procedure B.
Figure 11. Test Procedure A
[29]