Avaya Media Gateway G700 Manuel D’Utilisation

Manual upgrade of an existing G700 without an S8300 to R3.1

728 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server

Installing new firmware on the P330 stack processor

To install P330 stack processor firmware

1. At the P330-1(configure)# prompt, type

copy tftp SW_image <file> EW_archive <ew_file>

<tftp_server_address> <Module#>

where <file> is the full-path name for the image file with format and vintage number
similar to viisa3_8_2.exe,

<ew_file>

is the full-path name for the embedded web application file with format similar

to p330Tweb.3.8.6.exe,

<tftp_server_ip_address>

is the IP address of the TFTP server, and

<Module#>

is the number, 1 through 10, of the media gateway in the stack. If there is only

one G700 media gateway, the number is 1.

2. Verify that the download was successful when the prompt returns:

a. type show image version <module #> and check the version number in the

Version column for Bank B.

b. type dir <module #> and check the version number in the ver num column for the

EW_Archive file.

3. Type reset <module #>.

Installing new firmware on the G700 Media Gateway Processor

To install MGP firmware

1. At the P330-1(configure)# prompt, type session mgp to reach the G700 media gateway

processor.

2. Type configure at the MG-???-1(super)# prompt to enter configuration mode, which will

change the prompt to MG-???-1(configure)#.

3. At the MG-???-1(configure)# prompt, type show mgp bootimage to determine which

disk partition (bank) is in the Active Now column.

You will update the bank that is not listed as Active Now. The system displays the following
screen: