Avaya S8710 Manuel D’Utilisation
4 Connecting to the IPSIs
Programming the IPSI circuit packs
52
Installing and Configuring the Avaya S8700 or S8710 Media Server
June 2004
Figure 1: Connecting directly to the IPSI
NOTE:
Make sure you have the password before proceeding.
1
Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
2
From the services laptop Start Menu, click Start > Run to open the Run dialog box.
3
Type
command
and press Enter
to open a MS-DOS Command Line window.
4
Type
arp -d 192.11.13.6
and press
Enter
to clear the ARP cache in the laptop. This command
responds with one of the following:
•
The command line prompt when the cache has been cleared.
•
The phrase: The specified entry was not found. This is returned when the specified IP
address does not currently contain an entry in the ARP cache.
address does not currently contain an entry in the ARP cache.
5
Type
telnet 192.11.13.6
and press Enter to open the Telnet window and connect to the IPSI
Prompt = [IPSI]:
NOTE:
While connected to the IPSI, type
help
or
?
to obtain online help. Most commands have
two or three letter abbreviations.
Figure notes
1
Services laptop
2
PCMCIA Network Interface Card (NIC)
3
NIC adapter cable (if necessary)
4
CAT5 crossover cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
E
R
V
I
C
E
E
N
E
T
E
T
W
O
O
R
K
K
3
4