Aton DH46X Manuel D’Utilisation
© 2008 • All rights reserved. 15
DH46X 4 Source, 6 Zone Digital Audio Expansion Router
Cat-5
Cat-5
Cat-5
Cat-5
DHTP1 Rear
DHTP1 Rear
DHTP1 Rear
DHTP1 Rear
DH46X
DHTP1 Rear
DHTP1 Rear
Cat-5
Figure 3-4: ZONE OUT Connections
DHTP1 Speaker Connections
The DH46X sends a digital audio signal to connected DHTP1 Touch Pads where it is amplifi ed
and sent to speakers.
and sent to speakers.
WARNING!: The DHTP1’s amplifi er is capable of powering a single pair of 8-6 Ohm speak-
ers. DO NOT connect speakers with a rating of less than 6 Ohms! DO NOT connect more
than one speaker to either speaker connector of the DHTP1. In doing this, damage to the
DHTP1 may occur and will void the products warranty.
ers. DO NOT connect speakers with a rating of less than 6 Ohms! DO NOT connect more
than one speaker to either speaker connector of the DHTP1. In doing this, damage to the
DHTP1 may occur and will void the products warranty.
To connect speakers to DHTP1 Touch Pads:
Ensure that system power is OFF!
Remove the SPEAKER CONNECTOR from the DHTP1
Strip speaker wire back 1/4"
Loosen speaker terminal screws on the speaker connectors
Insert speaker wires into terminals making sure to maintain +/- polarity
Tighten screws on speaker terminals
Re-connect the terminal strip to the SPEAKER CONNECTOR on the DHTP1
Connect speaker wires to the room speakers maintaining correct polarity
Remove the SPEAKER CONNECTOR from the DHTP1
Strip speaker wire back 1/4"
Loosen speaker terminal screws on the speaker connectors
Insert speaker wires into terminals making sure to maintain +/- polarity
Tighten screws on speaker terminals
Re-connect the terminal strip to the SPEAKER CONNECTOR on the DHTP1
Connect speaker wires to the room speakers maintaining correct polarity
1.
2.
3.
4.
5.
6.
7.
8.
2.
3.
4.
5.
6.
7.
8.