Atmel AVR2070 Manuel D’Utilisation
AVR2070
77
8240B-AVR-06/09
D.3.5 Programming the FLASH
First programming the FLASH memory with SAM-PROG will be covered. With the
SAM-ICE connected, open the SAM-PROG program. Point to the file at
Applications\UTaskerV1.3\GNU_SAM7X\uTaskerV1.3.bin. Ensure the “None” and
“Auto-mode” checkbox are checked.
SAM-ICE connected, open the SAM-PROG program. Point to the file at
Applications\UTaskerV1.3\GNU_SAM7X\uTaskerV1.3.bin. Ensure the “None” and
“Auto-mode” checkbox are checked.
Figure D-3-10 SAM-PROG Flash Programmer
Then hit the “Yes” button under “Target Connected”, and the device should be
programmed. With the FLASH programmed, it is now a matter of debugging the
program.
programmed. With the FLASH programmed, it is now a matter of debugging the
program.
Start the GDB server from the Windows Program menu. It can be found under
Windows Start -> All Programs -> SEGGER under “J-Link ARM V3.96b / J-Link GDB
Server”. Note that both the GDB server and SAM-PROG can be run at the same time,
provided both programs do not access the SAM-ICE at the same time. An indication
the J-Link is connected should appear:
Windows Start -> All Programs -> SEGGER under “J-Link ARM V3.96b / J-Link GDB
Server”. Note that both the GDB server and SAM-PROG can be run at the same time,
provided both programs do not access the SAM-ICE at the same time. An indication
the J-Link is connected should appear: