Apex Digital 5708009-C Manuel D’Utilisation
1-16
5708009-C
Advanced Energy
®
Conditions of Use
To be in compliance with the stated directives and standards, you must meet the
following conditions of use.
following conditions of use.
•
This device must be used in an overvoltage category II installation only.
•
Before making any other connection, connect the auxiliary Protective Earth
ground conductor on the rear panel.
ground conductor on the rear panel.
•
Use only a shielded cable on the input power connector.
•
Use only a shielded power cable on the output power connector.
•
Install and operate this device only in a pollution degree 2 or better environment,
which means an indoor location such as a computer room, office, or factory floor
where only non-conductive pollution occurs during operation. Occasionally, a
temporary conductivity caused by condensation occurs when the device is not
operating.
which means an indoor location such as a computer room, office, or factory floor
where only non-conductive pollution occurs during operation. Occasionally, a
temporary conductivity caused by condensation occurs when the device is not
operating.
•
Non-standard connectors for input and/or output power must be inaccessible to
the user.
the user.
•
If your unit does not have a circuit breaker, install and operate it with a circuit
breaker on the ac input to provide over current protection. The circuit breaker
must have a trip value as specified in the line current section of Table 3-2. on
page 3-5.
breaker on the ac input to provide over current protection. The circuit breaker
must have a trip value as specified in the line current section of Table 3-2. on
page 3-5.