Amana Ice Maker IA 52204-0001 Manuel D’Utilisation
4
A
B
C
A Phillips screws
C Center hinge shim
B Center hinge
6.
Reverse bottom hinge pin:
• Remove toe grille by grasping both ends and pulling
straight out from unit. Grille snaps free.
A
A Toe grille
• Exchange hinge pin from bottom hinge assembly
with outward hinge plug from opposite bottom hinge
assembly.
assembly.
A
B
A Hinge pin
B
Hinge plug
7.
Reverse door stops:
• Locate door stop at bottom edge of refrigerator door.
Unscrew two Phillips screws to remove door stop.
Remove the two Phillips screws on opposite edge of
door. Mount door stop on opposite side. Replace
remaining screws in empty mounting holes.
Remove the two Phillips screws on opposite edge of
door. Mount door stop on opposite side. Replace
remaining screws in empty mounting holes.
• Repeat the above instructions to reverse door stop
on freezer door.
B
A
A
A Screws
B
Door stop
8.
Replace doors:
• Rehang freezer door by setting freezer door hinge
hole on bottom hinge pin.
• While supporting freezer door, insert internal
support rod into hinge socket, and install center
hinge pin into the center hinge bracket.
hinge pin into the center hinge bracket.
• Tighten down center hinge pin with a ¼" hex nut
driver to hold door in place. Make sure fit is snug.
• Locate 3 plugs at top of cabinet. Transfer plugs to
holes left by hinge removal.
• Assemble top hinge, hinge shim(s), and positioning
shim together. Attach loosely to opposite side of
cabinet to allow for door clearance.
cabinet to allow for door clearance.
3.
Remove doors
:
• Remove top hinge cover. Top hinge cover snaps off.
While supporting refrigerator door, remove top hinge
and hinge shim using
and hinge shim using
5
/
16
” hex nut driver. Peel
positive positioning shim from cabinet. Remove and
retain all shims.
retain all shims.
• Keep adhesive surface of shim free of dirt and dust
until ready to replace during top hinge reversal.
Contamination of adhesive surface will prevent
proper reinstallation.
Contamination of adhesive surface will prevent
proper reinstallation.
A
E
D
C
B
A Top hinge cover
D Hinge shim
B
5
/
16
" hex nut screws
E
Positive positioning
C Top hinge
shim
• Remove refrigerator door by lifting door off center
hinge pin. Inspect door to verify all shims are with
pin assembly.
pin assembly.
• Remove center hinge pin using ¼" hex nut driver.
Due to tight fit of pin, firm pressure may need to be
applied. Remove and retain all washer shims.
applied. Remove and retain all washer shims.
• Remove freezer door by lifting door off bottom
hinge pin.
B
C
A
A Washer shims
C Center hinge
B Center hinge pin
4.
Remove internal support rod(some models):
• Some models have an internal support rod
(see
below) installed in the hinge socket of door. If
present, remove and retain for later replacement.
present, remove and retain for later replacement.
A
A Support rod (some models)
5.
Reverse center hinge:
• Remove center hinge bracket and shims by
removing screws using a Phillips screwdriver.
• Remove 3 screws opposite of center hinge and
transfer to opposite side of cabinet.
• Install bracket on opposite side of cabinet with
shims.