ALTINEX AP445-401 Manuel D’Utilisation
SPECIAL APPLICATION
400-0422-001
10
7. [STAT]
This command displays the status of the
AP445-401.
AP445-401.
Command Format: [STAT] or [STATCi]
Ci = Unit ID (i = # from 0 to 99)
Example 1:
Send the command [STATC1] and receive
feedback showing the status of unit ID 1.
feedback showing the status of unit ID 1.
Example 2:
Send the command [STAT] and receive
feedback showing the status of the unit
connected to the RS-232 port regardless of its
unit ID.
feedback showing the status of the unit
connected to the RS-232 port regardless of its
unit ID.
8. [STATS]
This command displays the status of the
AP445-401 and saves the settings in memory.
AP445-401 and saves the settings in memory.
Command Format: [STATS] or [STATCiS]
Example:
Send the command [STATS] and receive
feedback as in the previous example, but in this
case the settings will be saved and recalled
when the same input is selected using the [INR]
command.
feedback as in the previous example, but in this
case the settings will be saved and recalled
when the same input is selected using the [INR]
command.
9. [CLR]
Reset all parameters to factory defaults.
Command Format: [CLRCi]
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [CLR] to reset the unit to
the factory defaults. After reset, the status will
similar to the following depending on the input
selected:
the factory defaults. After reset, the status will
similar to the following depending on the input
selected:
Input: S-Video
Default
Output Resolution: 640x480
Last Saved
Brightness: 24
Last Saved
Contrast: 40
Last Saved
Color: 24
Last Saved
Sharpness: 10
Last Saved
Hue: 24
Last Saved
Audio Volume: 32
Default
VCR Mode
Default
NR ON
Default
Aspect Ration 4:3
Default
Freeze OFF
Default
Front Panel Unlocked
Last Saved
10. [IN]
This command selects the input port on the unit
to be used as the source.
to be used as the source.
Command Format: [INyCi]
y
= Input (y = # from 0 to 3)
0 =
S-Video
1 =
Composite Video
2 =
PC Bypass
3 =
YPbPr Video
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [IN0] to select the S- Video
input.
input.
11. [INR]
This command selects the input port on the unit
to be used as the source and recalls the saved
settings.
to be used as the source and recalls the saved
settings.
Command Format: [INyRCi]
y
= Resolution (y = # from 0 to 3)
0 =
S-Video
1 =
Composite Video
2 =
PC Bypass
3 =
YPbPr Video
R = Recall image property settings
Ci = Unit ID (i = # from 0 to 99)