Alamo GR60 Manuel D’Utilisation

GR60/72   02/07

Operation Section 4-13

© 2007 Alamo Group Inc.

When fitting the mower to the tractor, the telescoping driveline must be inspected to ensure that at its most

compressed position, the profiles do not “bottom out”, and when at its farthest extended position, there is

sufficient engagement between the profiles to operate safely.  At its shortest length, there must be at least a 1”

clearance between each profile end and opposite profile universal joint.  At its farthest operating extension, a

minimum profile engagement of 9” must be maintained.

Before operating the Implement, check to make sure the Implement input driveline will not

bottom out or become disengaged.  Bottoming out occurs when the inner shaft penetrates

the outer housing until the assembly becomes solid-it can shorten no more.  Bottoming out can cause serious

damage to the Tractor PTO by pushing the PTO into the Tractor and through the support bearings or

downward onto the PTO shaft, breaking it off. A broken drive line can cause personal injury.

 (S3PT-18)

•

Disconnect driveline from the tractor and slide 
the profiles together until fully compressed. 

•

Place a mark  on the inner shield  1/8” from the 
end of the outer shield.

•

Reattach the driveline to the PTO Shaft.

•

Raise the mower and watch the driveline as it 
approaches the mark.  If the distance between 
the mark and the end of the outer shield tube 
becomes less than 2” at any point, the driveline 
must be shortened.   OPS-R-0004_A