ADT Security Services ADT-LCD40 Manuel D’Utilisation

Page de 36
Mounting
ADT-LCD40 Series Preparation
17
Document 50520    Rev D   7/25/00   P/N 50520:D
Section 3:          
Mounting
3.1
ADT-LCD40 Series Preparation
The ADT-LCD40 Series Annunciators can be surface mounted in a 
three-gang electrical box such as the P/N SBB-3 (2.75" depth) or semi-
flush mounted in a three-gang electrical box, P/N 10103 or equivalent, 
with a minimum depth of 2 3/16".  The ADT-LCD40 Series Annuncia-
tors cannot be mounted in three gangable electrical switch boxes con-
nected together.  Select and remove the appropriate knockout(s), pull the 
necessary wires through the knockouts and mount the three-gang box in 
or on the wall depending on the type of installation desired.  Be certain 
that power is not applied to the wiring during the installation procedure.
Note: To ensure static protection, all enclosures, including the 
ADT-LCD40 Series electrical box, must be connected to earth ground!  
Never use the shield for grounding purposes.
To mount the ADT-LCD40 Series Annunciators in an electrical box, the 
trim ring must first be removed.  The trim ring is held in place by two 
screws inserted through the top and bottom edge as illustrated in Figure 
3-1.  Removal of the trim ring will expose a metal flange with mounting 
holes.  Refer to “Hardware and Backboxes” on page 18. 
A ck
S ilen c e
R eset
D rill
H o ld   2  s ec .
F IR E   A LA R M   A N N U N C IATO R
Figure 3-1: Trim Ring Removal
Screw
Screw